Basically
an o ring is used to block a pathway that fluid or air may escape
through. O rings are usually put into a groove to hold them in place
and then squeezed between two surfaces. When an O ring is squeezed
between two surfaces it shall be taking up the clearance and blocking
the pathway that the fluid or air wants to escape through. After an O
ring is applied by squeezing, the rubber once again takes up its
original shape. This is how the O rings seal under very low or no
pressure. When pressure is applied to the system this also helps the
O ring seal by pushing the O ring against the groove wall opposite
the direction of the pressure and forcing it expand perpendicular to
the direction it is being squeezed by the pressure.
Square
cut O rings are circular lathe cut seals with square cross section.
The square cut gaskets and O rings are perfect replacement for
standard O rings in most static and some dynamic applications.
Darcoid
Nor-Cal Seal is the exclusive manufacturer of square cut O rings and gaskets. These
square cut gaskets and o-rings come as TetraSeals from Darcoid
Nor-Cal Seal and are available in a wide variety of elastomeric
compounds. These square cut o-rings and gaskets from Darcoid Nor-Cal
Seal have gained a widespread acceptance and are used extensively in
many industries, including automotive, off road, diesel engines,
medical and numerous industrial applications.
The
product extensively from the house of Darcoid Nor-Cal Seal suits
perfectly the need for high quality, economical, static seals used in
industries like automotive, medical, and many other engineering
applications. Darcoid
Nor-Cal Seal has on offer a wide range of sizes in regard to square
cut o-rings and gaskets. Standard
TetraSeals, manufactured by Darcoid range in sizes from 3/16 inches
up to 18 inches on the inside diameter with standard cross sections
from .066 inch to .265 inch. In addition to the typical square or
rectangular cross sections, a number of special cross sectional
configurations are available within the standard size range. The
square cut O rings also come in various dimensions. It is always
recommended to choose an appropriate AS-568A related TS dash number
that is shown in the charts, when you go on to select a standard
TetraSeal to replace a standard size O ring. Darcoid
Nor-Cal Seal has on offer perfectly manufactured square cut O rings
and gaskets.
The
process of manufacturing these square cut o-rings and gaskets is
excellent, so as to render absolutely homogeneous products. Square
cut O rings and gaskets manufactured by Darcoid company, under that
brand name TetraSeal are completely homogeneous, without any
parting-line indentations. A TetraSeal from the house of Darcoid
Nor-Cal Seal does not have any ragged flash extensions or backrind.
There
are no joints, laminations or void in this exclusive product from the
house of Darcoid seals. Darcoid Nor-Cal Seal uses state of the art
grinding equipment to finish outer surfaces to close tolerances.
Darcoid's exclusive product, TetraSeal, square lathe cut O rings and
gaskets are known to be suitable for high speed, precision and large
volume producing machinery and manufacturing units.
Darcoid
Nor-Cal Seal is a world renowned manufacturer of sealing solutions
and a wide range of accessories like EMI shielding seals and gaskets,
die cut gaskets, square
cut o rings and gaskets,
spliced O rings, and a distributor for the top manufacturers of
seals, gaskets and rubber products. Darcoid is an expert in supply
chain management and value added distribution services, resulting in
high quality seals and good cost value solution for your company.